Garmin GPS and Glonass GA 38

2024-05-14T20:14:17+02:00

Preis: 106.79

Designed to take advantage of the GLONASS system or satellite constellations, in addition to the standard GPS, this sturdy outdoor antenna incorporates a water-resistant low-profile housing and provides three simple mounting solutions: pole, surface or under deck (for the bottom of fiberglass covers).

The external GPS and GLONASS antennas provide greater flexibility and more installation options, as well as the power necessary to achieve better reception of the GPS or GLONASS signal, for products with built-in GPS or GLONASS antennas.

Specifications:

Dimensions (Pr. X H.): 91.6 mm X 49.5 mm (3 19/32′′ X 1 15/18′′)

Weight: 201 g (7.1 oz)

Temperature range: from -30 °C to 80 °C (from -22 °F to 176 °F)

Case material: fully sealed plastic alloy with high impact resistance, water resistant in accordance with IPX7 standards

FAQs

What are the safety recommendations during installation?

Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.

What is the required thread specification for pole mounting?

The pole must be standard 1 in. OD, 14 threads per inch, pipe-threaded (not included).

What connector type does the GA 38 antenna use?

The GA 38 antenna uses a BNC connector to connect to compatible Garmin chartplotters.

What is the advised compass-safe distance for the antenna?

Maintain at least 114 mm (4.5 in.) between the antenna and any compass.

What are the recommended mounting locations for best signal?

It should be mounted where there is a clear, unobstructed view of the sky, away from superstructures, radomes, and masts.

What steps are recommended before permanent mounting?

Temporarily secure and test the antenna for correct operation to ensure there is no interference.

Does the antenna support different mounting methods?

Yes, it supports surface, pole, and under-deck (fiberglass only) mounting options.

Can the GA 38 be mounted under a metal deck?

No, the antenna cannot acquire signals through metal and must be mounted under a fiberglass surface only.