Harken Performa Alum Self-Tailing Winch

2026-03-20T15:37:15+01:00

Precio: 558.97 - 13956.12 (14 variants)

Key details

Product type: Performa Alum Self-Tailing Winch

Options: Model, Speed

Available variants: 14

Overview

All Performa™ winches feature sandblasted drums optimized for halyard and sheeting applications using small-diameter, high-tech line. Self-tailing winches have narrow composite jaws to ensure superior holding power on small-diameter line. The self-tailing mechanism on the winch means that one crew member can quickly and easily trim or raise sails.

Specifications

Specifications vary by the selected variant. Use the variant table below to compare the available configurations and part numbers.

Variant details

Select the option combination that matches the required part number.

Model | Speed | Part No.
20 | 1 | 20STP
30 | 2 | 30.2STP
35 | 2 | 35.2STP
40 | 2 | 40.2STP
46 | 2 | 46.2STP
50 | 2 | 50.2STP
50 | 3 | 50.3STP
55 | 3 | 55.3STP
60 | 2 | 60.2STP
60 | 3 | 60.3STP
70 | 2 | 70.2STP
70 | 3 | 70.3STP
80 | 2 | 80.2STP
80 | 3 | 80.3STP

FAQs

What tools are required for installation and disassembly?

You'll need one medium flat-bladed screwdriver and a number five hex key for installation and maintenance.

Who should install or service the winch?

Installation and maintenance should only be done by specialized personnel or expert users.

What are the main installation requirements for deck mounting?

Install the winch on a flat, reinforced deck able to bear at least twice the maximum working load.

How do you maintain the drainage channels during installation?

Make sure holes and drainage channels in the base of the winch are not obstructed before final assembly.

What structural requirements are there for deck mounting?

Install the winch on a flat, reinforced deck able to bear at least twice the maximum working load. Deck tests are the installer's responsibility.

What are the annual maintenance requirements?

Winches must be completely overhauled, cleaned and lubricated at least every 12 months.

Is a drilling template available for installation?

A reduced-scale diagram is included in the manual, and a drilling cut out template is available from Harken.

Are mounting bolts included?

Mounting bolts are not supplied by Harken and must be chosen by the installer.

What should you check before final reassembly after installation?

Make sure the holes and drainage channels in the winch base are not obstructed.

What should be done if you are unsure about installation or servicing?

Contact Harken Tech Service for expert advice if in doubt.

What is a key safety warning for installation?

Failure to use correct fasteners or deck strength can result in winch pulling off deck and causing severe injury or death.

What tools are needed for installation and disassembly?

You need a medium flat-bladed screwdriver and a number five hex key for installation and service.

What material and type should mounting bolts be?

Use only bolts in A4 stainless steel (DIN 267 part11). Do not use countersunk bolts for deck mounting.

How do you position the winch's drive gear?

The drive gear must be placed where the sheet enters the winch drum.

How often should the winch be washed?

Wash frequently with fresh water, at least after each use.

What must be inspected at the start and end of the season?

Visually inspect winches at the beginning and end of every season.

Should you use generic parts for repairs?

Only original parts should be used—do not replace with non-original parts.