Navico FORWARDSCAN SLEEVE AND PLUG-NO XDCR

ForwardScan suits almost any vessel and hull type, with a stainless steel through-hull mounting sleeve. The sleeve and an optional fairing block can accommodate up to 29 mm (1.15 inch) thick hulls at 12 degrees deadrise, or up to 19 mm (3/4 inch) thick hulls at 20 degrees.

A built-in self-closing valve means the ForwardScan transducer can be inserted and removed from the sleeve while on the water, simplifying transducer installation and maintenance.

By pre-installing the ForwardScan sleeve and fitting the included watertight blanking plug, boat builders can make a new vessel ForwardScan-ready and allow the transducer to be added later as a DIY on-water upgrade.

• Stainless steel sleeve for the standard ForwardScan transducer.
• Suits hulls up to 29 mm (1.15 inches) thick.
• Self-closing valve allows on-water transducer removal.
• Includes blanking plug.

Weight	1 kg
Dimensions	19.96 × 25.4 × 9.52 cm
Brand	Navico
Family	FORWARDSCAN
Model	Mount
Class Type	Sonar
Component	Sensor/Transducer/Scanner/Antenna
Item Type	Accessory

The following products are from the same Category as this one: