Harken Performa 전동 ST 알루미늄 윈치 (듀얼 기능 컨트롤 박스 포함)

The product includes a limited worldwide warranty; details are in the installation and maintenance manual.

The winch must be installed on a flat area of the deck, reinforced if necessary to bear a load at least twice the maximum working load of the winch.

Hex screws should be tightened to 20Nm (177 in-lb) during assembly procedures.

When assembling, tighten the six hex screws with a torque of 20 Nm (177 in-lb) during installation steps involving these screws.

It should be completely overhauled, cleaned, and lubricated at least every 12 months, or sooner if signs of wear are noted.

The sheet entry angle must be 8° with a tolerance of ±2° to avoid overrides that can damage the winch or make it inoperable, causing loss of control.

Wash the winch frequently with fresh water after each use. Avoid caustic cleaners, solvents, polishes, or abrasive pastes on anodized, chrome, or plastic parts.

Pawls and springs should be lightly lubricated with oil only, and no grease should be applied to pawls.

No, countersunk bolts must not be used when mounting the winch on the deck.

The winch must be installed on a flat deck area reinforced to bear at least twice the maximum working load of the winch.

The deck must be reinforced to bear at least twice the maximum working load of the winch to ensure safety.

Use only A4 stainless steel (DIN 267 part11) bolts to install the winch. Bolts of other materials may corrode or lack strength, risking sudden deck failure.

Use only A4 stainless steel bolts (DIN 267 part11). Other materials may corrode or lack strength, risking winch failure causing injury or death.

Only use A4 stainless steel bolts (DIN 267 part11) for installing the winch to prevent corrosion and ensure strength.

A4 stainless steel bolts are recommended to provide sufficient strength and corrosion resistance, preventing sudden deck failure under high loads.

The entry angle of the sheet must be 8° with a tolerance of ±2° to avoid sheet overrides that can damage the winch or cause it to malfunction.

The winch requires six M8 socket head or hexagonal headed bolts to be securely mounted to the deck, chosen to suit the deck thickness and type.

The winch must be bolted to the deck using six M8 bolts, either Socket Head (SH) or hexagonal headed, correctly chosen for the boat deck thickness and type.

Mount the winch so the drive gear is positioned where the sheet enters the winch drum to avoid weakening the winch and potential failure causing injury.

The maximum working load (MWL) for the 60.3 ST Performa™ Winch is 1800 Kg (3968 lb). Exceeding this load can cause winch failure and serious injury.

A torque wrench is recommended to obtain a tightening torque no greater than 10 Nm (88 in-lb) for motor cable terminal nuts.

Wash the winch frequently with fresh water after each use, avoiding teak cleaners or caustic products. Do not use solvents or abrasive pastes on anodized or plastic parts.

Complete overhaul, cleaning, and lubrication should be performed at least every 12 months, with visual inspections at start and end of sailing or racing seasons.

The theoretical power ratio for the 1st speed gear is 9.2:1.

Contact the SailRACE team — as certified marine experts we're happy to help with product selection, installation and after-sales servicing, before and after your purchase.